Flash Lamps as Ignition and Initiation Sources of the VS-2 Pyrotechnic Composition

In the present work it is found that the pyrotechnic composition VS-2 can be initiated with flash lamps IFC-500 and EVIS. VS-2 pyrotechnic composition contains 90% of mercury（Ⅱ） 5-hydrazinotetrazolate perchlorate and 10% of optically transparent copolymer of 2-methyl-5-vinyltetrazole and methacrylic acid （PVMT）. We have found that the flash lamps make it possible to initiate combustion of VS-2 composition with its transition to detonation both in cylindrical charges placed in brass caps of 5 mm diameter and 2 mm high， and film charges with 10 mm×80 mm in size and surface weights of 60 mg·cm^-2 and 90 mg·cm^-2， showing ignition delay times 10 μs and 3 μs， respectively. We also measured detonation velocities for VS-2 composition film charges， which were 4375-4505 m·s^-1 （of the charge being surface mass 60 mg·cm^-2） and 4221-4281 m·s^-1 （of the charge being surface mass 90 mg·cm^-2） and their blasting action on the aluminum plate. The depths of the normal shock wave imprints at the charge-barrier interface were 0.6-0.7 mm （for surface mass of the film charges 60 mg·cm^-2） and 1.2-1.3 mm （for surface mass of the film charges 90 mg·cm^-2）.     

“数字信号处理”课程的几何视角

“数字信号处理”的经典课程体系以“系统”为中心，以离散时间傅立叶变换、z变换和离散傅立叶变换为分析工具，以滤波器设计为目的，注重定理和公式推导及其性质分析，很难让学生建立一个形象的、完整统一的知识体系框架。本文从几何视角将 “系统”化和“代数”化的经典课程体系重构为面向“信号”的“几何”知识体系，从而提升学生对本质问题的“洞察力”，帮助学生建立系统的知识体系。     

Dynamic voltage scaling based energy-minimized partial task offloading in fog networks

Wireless Networks - With the dynamic voltage scaling (DVS) technology, the terminal node (TN) can dynamically adjust its computational speed, thus providing a new way to save energy during task...     

Graph-Theoretic Method on Topology Identification of Stochastic Multi-weighted Complex Networks with Time-Varying Delayed Coupling Based on Adaptive Synchronization

Neural Processing Letters - This paper is concerned with topology identification of stochastic multi-weighted complex networks based on adaptive synchronization. Different from previous work,...     

Effects of structural parameters on water film properties of transpiring wall reactor

Corrosion and salt deposition problems severely restrict the industrialization of supercritical water oxidation. Transpiring wall reactor can effectively weaken these two problems by a protective water film. In this work, methanol was selected as organic matter, and the influences of vital structural parameters on water film properties and organic matter removal were studied via numerical simulation. The results indicate that higher than 99% of methanol conversion could be obtained and hardly affected by transpiration water layer, transpiring wall porosity and inner diameter. Increasing layer and porosity reduced reactor center temperature, but inner diameter's influence was lower relatively. Water film temperature reduced but coverage rate raised as layer, porosity, and inner diameter increased. Notably, the whole reactor was in supercritical state and coverage rate was only approximately 85% in the case of one layer. Increasing reactor length affected slightly the volume of the upper supercritical zone but enlarged the subcritical zone.     

盾构隧道施工物料无人运输发展现状及关键技术

盾构隧道施工物料无人运输有助于提升运输效率、降低运输成本、减少运输安全事故率。与公路汽车无人驾驶、港口车辆无人驾驶、轨道交通无人驾驶等逐步成熟的无人驾驶技术不同，在隧道场景下实施施工物料无人运输存在运输物料种类繁多、运输调度困难、地下定位信号拒止、狭窄车道频繁会车、行车路面工况复杂、地上地下联动响应慢等诸多挑战。从实现盾构隧道施工物料无人运输的关键问题分析入手，综述当前盾构隧道施工物料运输方式、运输需求、无人运输发展现状及存在的挑战，提出盾构隧道施工物料无人运输的五大关键技术：多种类物料智能货控能效管理技术，无人化垂直装卸门机控制技术，多传感器融合同步定位与地图构建技术，隧道复杂环境路径规划与自主避障技术，隧-地一体化联动响应的高可靠性无线通信技术。     

放电参数变化对电感耦合等离子闭式等离子体空间分布特性研究

射频电感耦合等离子体（ICP）在实际放电过程中，线圈的构型、电源参数、气压等外部工质条件的变化均会对结果产生较大影响，依靠实验很难得到多外部条件对ICP参数分布的影响机理和规律，因此需要结合仿真和实验的方法进行分析。该文通过建立感性线圈的电磁学有限元模型，分析不同线圈构型下射频电磁场在等离子体内部的空间分布，研究放电参数（线圈构型、功率大小）对等离子体分布影响和E-H模型下放电形态的跳变过程，并观察进入稳定H模式后电源参数的变化规律，为等离子体源的小型化工程应用提供理论基础。实验和仿真计算结果表明：不同线圈匝数在不同功率条件下，电磁场强度变化对等离子功率吸收和功率耦合有较大影响；当工作气压在0～20Pa时，ICP的电子密度呈轴对称分布，随着放电功率、气压的增大，等离子体吸收的功率和电离度也随之增加，其电子密度相应地增大，放电功率的增加会使得环状的等离子体区域随之扩大，在轴向、径向上的分布呈先逐渐增大而后在靠近腔室壁面区域迅速下降。     

双亲纳米SiO2颗粒的制备及提高渗吸采收率性能

以正辛基三乙氧基硅烷和3-巯基丙基三乙氧基硅烷为改性剂，以双氧水为氧化剂，在水基环境下对亲水纳米SiO2颗粒表面进行改性，得到具有磺酸基和辛基的双亲纳米SiO2颗粒，并通过红外和热重对其化学结构和热稳定性进行分析。将双亲纳米SiO2颗粒分散在地层水中制备纳米流体，并评价纳米流体的稳定性、界面性质和渗吸效率。利用核磁共振技术探究纳米流体渗吸过程中岩心孔隙内原油运移规律。结果表明，纳米流体储存30 d未出现分层现象，表现出良好的稳定性；经纳米流体处理的岩心亲水性增强。此外，双亲纳米SiO2颗粒将油水界面张力降低至1.7 mN/m；纳米流体渗吸采收率高达22.6%，渗吸初始阶段小孔隙中的原油被动用，而在渗吸后期阶段大孔隙中的原油才被动用。